Marmitek AWM2 Modo De Empleo página 12

program the preferred settings (When you use an RF remote control
like the Marmitek 8-in-1, then a TM13 Plug-in Transceiver is required
to convert the RF signals to the X-10 commands on the power line).
example 1. Program the Marmitek X-10 address e4:
• Setup your remote control (see manual 8-in-1) and the TM13
transceiver to house code E.
• Start with the MicroModule in setup mode.
• Press the Marmitek X-10 button (marked with the symbol of a
house) of the 8-in-1 remote control and then press button 4.
• Press the "ON" button 2x (= channel+).
• The MicroModule responds by blinking the LEd twice.
• The address E4 is programmed.
example 2. Program the function "All Units Off"
• Make sure you program the required Marmitek X-10 address
first!! (e.g. E4).
• Leave the remote control and the TM13 Transceiver on
HouseCode E or set it to the right HouseCode.
• Start with the MicroModule in setup mode.
• Press button marked with "All Units Off" 2x (= mute).
• The MicroModule responds by blinking the LEd 8x.
NOTes:
• When you program the MicroModule, always program the
address first followed by the optional functions.
• If the MicroModule receives a new address during setup mode,
the optional functions will be automatically reset to the factory
defaults.
• If you have programmed the address, but you wish to change it
again you need to switch the AWM2 out of the programming
mode and put it in the programming mode again.
• When programming the AWM2, do not give the commands with
too little time in between, keep 1 second pauses in between the
commands.
12 © MARMiTeK