Gewiss Easy GW 10 753 Manual De Instrucciones página 20

ATTENTION: the device must only be installed by qualified personnel,
observing the current regulations and guidelines for KNX installations.
Recommendations for installing the KNX
1. The length of the bus line between the push-button panel and the power supply unit
must not exceed 350 metres.
2. The length of the bus line between the push-button panel and the furthest KNX device
to be controlled must not exceed 700 metres.
3. To avoid unwanted signals and overvoltages, do not use ring circuits.
4. Keep a distance of at least 4mm between the individually insulated cables of the bus
line and those of the electricity line (figure D).
5. Do not damage the electrical continuity conductor of the shielding (figure E).
ATTENTION: The unused bus signal cables, and the electrical continuity
conductor, must never touch any live elements or the earthing
conductor!
Figure B shows a diagram of the electrical connections.
1. Connect the red wire of the bus cable to the red clamp (+) of the terminal, and the
black wire to the black clamp (-). Up to 4 bus lines can be connected to the bus
terminal (same coloured wires on the same terminal) (figure F).
2. Insulate the shield, the electrical continuity conductor, and the other white and yellow
wires of the bus cable (if a 4-conductor bus cable is being used), that are not
necessary (figure E).
3. Insert the bus clamp in the pins of the device. The correct insertion direction is
determined by the fixing guides. Insulate the bus terminal with the cover to be screwed
onto the device. The cover guarantees the minimum separation distance of 4mm
between the power cables and the bus cables (figure G ).
INSTALLATION
Electric connections
20