Descargar Imprimir esta página

Philips AZ 1574 Manual Del Usuario página 7

Ocultar thumbs Ver también para AZ 1574:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24
Tuning to radio stations
1. Select TUNER source.
is displayed briefly and then the radio station
frequency is shown.
2. Press BAND once or more to select your waveband.
3. Press SEARCH ∞ or § (on the remote control, TUNING ∞
or §) and release when the frequency in the display starts
running.
™ The tuner automatically tunes to a station of sufficient
reception. Display shows
™ If an FM station is received in stereo,
4. Repeat step 3 if necessary until you find the desired station.
• To tune to a weak station, press SEARCH ∞ or § briefly and
repeatedly until you have found optimal reception.
To improve radio reception:
• For FM, pull out the telescopic aerial.
Incline and turn the aerial. Reduce its length if the signal is
too strong (very close to a transmitter).
• For MW (AM or LW), the set is provided with a built-in aerial
so the telescopic aerial is not needed. Direct the aerial by
turning the whole set.
Programming radio stations
You can store up to a total of 30 radio stations in the memory.
1. Tune to your desired station (see Tuning to radio stations).
2. Press PROG to activate programming.
™ Display:
flashes.
PROG
3. Press PRESET 3 or 4 once or more to allocate a number
from 1 to 30 to this station.
4. Press PROG again to confirm the setting.
™ Display:
disappears, the preset number and the frequency
PROG
of the preset station are shown.
5. Repeat the above four steps to store other stations.
• You can overwrite a preset station by storing another
frequency in its place.
Tuning to preset stations
Press TUNER PRESET 4 or 3 until the desired preset station is
displayed.
during automatic tuning.
is shown.
STEREO
DIGITAL TUNER
7

Publicidad

loading