Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION PROCEDURE - Valves
1.
Thread a mounting nut to the bottom
of the valve. Place a washer and gasket
as shown.
NOTE: the hot water valve has a red
marking on side of body.
2.
Pass the valve up through the
installation hole.
Insert the O-ring and fasten the
collar to the valve body until it
stops.
3.
Fixate the valve by threading the
mounting nut up the valve until hand
tight. Tighten the retaining screws
equally to secure.
Do not overtighten!
4.
Repeat steps 1-3 for remaining valve.
NOTE: Hoses to connect valve inlets to water supply lines not included.
INSTALLATION PROCEDURE - Spout
5.
Place O-ring under spout.
Pass the supply hoses and
mounting stud through the
mounting hole until the spout
comes to rest.
Mounting
Screws
4
Gasket
Gasket
(Rubber)
(Rubber)
Washer
Washer
(Metal)
(Metal)
Mounting
Mounting
Nut
Nut
Collar
O-ring
Spout
O-ring
Publicidad
