Hama 221064 Instrucciones De Uso página 7

6.4 Deleting taught functions
6.4.1 Deleting a taught function
1. Press and hold the [MUTE] and [VOL+] buttons simultaneously
for approx. 5 sec. until the status LED lights up continuously.
5
2. Enter the code [9] [8] [1], the status LED flashes 2 times and then
lights up permanently again.
3. Press the button whose function you wish to delete. The status LED
flashes 3 times and the desired function is deleted.
6.4.2 Deleting all taught functions
1. Press and hold the [MUTE] and [VOL+] buttons simultaneously
for approx. 5 sec. until the status LED lights up continuously.
5
2. Enter the code [9] [8] [2], the status LED flashes 2 times and then
lights up permanently again.
3. Press the [OK] button, the status LED flashes 3 times and all taught-
in functions are deleted.
7. EASY mode
This remote control is equipped with an EASY mode function. This
allows you to limit the range of functions of this remote control to
essential functions. This prevents an accidental change of the TV
settings.
In EASY mode, the following buttons are available:
Power TV ON / OFF
Volume + / -
TV mute
CH Programme + / -
0-9 Numeric keys 0 - 9 for programme selection
TEXT Teletext ON/OFF
Selection of on-screen options
GUIDE Show the programme guide
(if supported by the TV)
TV
AV TV/AV input selection
Close menu
7.1 Deactivating EASY Mode
1. Press and hold the [MUTE] and [VOL+] buttons simultaneously
for approx. 5 sec. until the status LED lights up continuously.
5
2. Enter the code [9] [7] [0], the status LED flashes 2 times and then
lights up permanently again.
3. Press the [EXIT] button, the status LED flashes 3 times and EASY
mode is deactivated.
Note
If the remote control is in EASY mode, only the buttons indicated in
point 7 function. If one of these buttons is pressed, the status LED
lights up until the button is released. In normal mode, the status LED
ashes when a button is pressed.
8. Maintenance
• Never use old and new batteries in the replacement remote control
at the same time, as old batteries tend to leak and can lead to a loss
of performance.
• Never clean the replacement remote control with scouring agents or
harsh cleaning agents.
• Keep the replacement remote control free of dust by cleaning it with
a dry soft cloth.
9. Troubleshooting
Q. My replacement remote control does not work!
A. Check your TV. If the main switch on the device is off, the
replacement remote control cannot operate the device.
A. Check that the batteries are inserted correctly and that the polarity
has been observed.
A. Check that you have pressed the appropriate device button for the
device.
A. Replace the batteries if the battery level is low.
Q. My TV only responds to some button commands.
A. Try other codes until most of the buttons work properly.
F. Some button commands on the remote control are no longer
working?
A. EASY mode may be activated. Deactivate EASY mode as described
in point 7.2.
10. Warranty disclaimer
The manufacturer assumes no liability and provides no warranty for
damage resulting from improper installation/mounting, improper use of
the product or from failure to observe the operating instructions and/
or safety notes.
4