Publicidad
Idiomas disponibles
Idiomas disponibles
6.5
Advice on Using the Angle Grinder
Always use the auxiliary handle provided with the device. A well-controlled device greatly increases the
working precision.
In all cases, do not apply big pressure on the device. For the best results, only apply a slight pressure,
move slowly and hold the disc at an angle of 15° to 30°.
Only use wheels and discs suited for this angle grinder. Heavier discs can damage the spindle axle and
cause severe injuries.
Vibrating discs must be replaced immediately. Also, as a disc wears with use, the grinding efficiency will
reduce accordingly. Make sure to replace the disc when its diameter reaches 8 cm.
All abrasive discs are relatively fragile. Do not rough-handle them.
New discs should be cleaned with a brush prior using them. Always keep them dry and free from dust.
7.
Cleaning and Maintenance
Keep the ventilation openings clear, clean and dust-free at all times.
If the device is running erratically or something unusual occurs during use, immediately switch off the
device and unplug from the mains. Inspect the device before using it again. Repair must only be carried out
by a qualified technician.
If the supply cord is damaged, it must be replaced by a qualified technician.
Wipe with a damp cloth to keep it looking new. Do not use harsh chemicals, cleaning solvents or strong
detergents.
Clean the device and accessories before storing.
Storing
Store the device, its accessories and this user manual in the original packaging.
Always store in a cool and dry place.
Replacing Carbon Brushes
Carbon brushes should be changed regularly. It is highly recommended to change all brushes at the same
time.
Changing of the carbon brushes must only be carried out by a qualified technician.
8.
Technical Specifications
power supply .................................................................................................... 230 V~, 50 Hz
power consumption ...................................................................................................... 850 W
speed ................................................................................................................ 12000 t/min.
cable .............................................................................................................................. 2 m
disc diameter ............................................................................................................. 125 mm
spindle ............................................................................................................................M14
Use this device with original accessories only. Velleman nv cannot be held responsible in the event
of damage or injury resulting from (incorrect) use of this device. For more info concerning this
product and the latest version of this manual, please visit our website www.toolland.eu. The
information in this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All worldwide rights reserved. No part of this
manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
V. 01 – 11/07/2016
TM81011
6
©Velleman nv
Publicidad
