Publicidad
Idiomas disponibles
Idiomas disponibles
The toxic and corrosive materials below are in the
batteries used in this machine: Lithium-ion, a toxic
material.
WARNING
Discard all toxic materials in a specified manner to
prevent contamination of the environment. Before
discarding damaged or worn-out Lithium-ion batteries,
contact your local waste disposal agency, or the local
Environmental Protection Agency for information and
specific instructions. Take the batteries to a local
recycling and/or disposal center, certified for Lithium-
ion disposal.
WARNING
If the battery pack cracks or breaks, with or without
leaks, do not recharge it and do not use. Discard it
and replace with a new battery pack. DO NOT TRY
TO REPAIR IT! To prevent injury and risk of fire,
explosion, or electric shock, and to avoid damage to
the environment:
•
Cover the terminals of the battery with heavy-duty
adhesive tape.
•
DO NOT try to remove or destroy any of the
battery pack components.
•
DO NOT try to open the battery pack.
•
If a leak develops, the released electrolytes are
corrosive and toxic. DO NOT get the solution in the
eyes or on skin, and do not swallow it.
•
DO NOT put these batteries in your regular
household trash.
•
DO NOT incinerate.
•
DO NOT put them where they will become part of
any waste landfill or municipal solid waste stream.
•
Take them to a certified recycling or disposal
center.
12
INSTALLATION
12.1 UNPACK THE MACHINE
WARNING
Make sure that you correctly assemble the machine
before use.
WARNING
•
If the parts are damaged, do not use the machine.
•
If you do not have all the parts, do not operate the
machine.
•
If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
English
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
12.2 INSTALL THE LIGHT HEAD
•
Battery tools are always in operating condition.
Therefore, always turn off the light when the light
is not in use or when carrying the machine at your
side.
1. Align the bolt the the hole (on the bracket).
2. Insert the bolt into the hole until it kocks into place
and then tighten them with knobs.
3. Do the same operation on the other side.
12.3 REMOVE THE LIGHT HEAD
1. Unlock the right and left knobs.
2. Remove the bolts.
12.4 INSTALL THE BATTERY PACK
7
WARNING
EN
Publicidad
