Publicidad
Idiomas disponibles
Idiomas disponibles
HCS EVSE User Manual
EVSE Mounting for Solid-Wall Construction
•
To secure the unit in concrete, pre-drill appropriately sized holes
and use multi-set or wedge anchor hardware at both mounting
points.
•
To secure the unit in brick or stone, pre-drill appropriately sized
holes and use sleeve anchors at both mounting points.
•
The included plastic angle washers can be oriented to allow bolts
to be fastened either at an angle or perpendicular to the mounting
surface.
•
NOTE there are two different sets of plastic angle washers
included. Select those washers that best accommodate the
mounting hardware "angle of attack" and orient them accordingly.
•
NOTE that if the head of the mounting hardware is smaller than
the ⅜" (1 cm) plastic angle washer aperture, an additional flat
washer will need to be placed between the plastic angle washer
and the mounting hardware.
•
Machine screw size ¼"- 20 hardware is recommended for
mounting the EVSE. Screw shafts of at least 2" (5.1 cm) are
recommended. The EVSE plastic angle washer hole size is ⅜"
(1 cm) in diameter, ensure the screw heads are of a larger
diameter. Place appropriately sized washers between the screw
heads and the HCS enclosure mounting flanges.
Figure 9: Mounting EVSE to a Solid-Wall
17"
24
Publicidad
