Descargar Imprimir esta página

Qlima FFB 105 Instrucciones De Uso página 24

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1
Possible suitable extinguishers are of class B and use:
NEVER extinguish with water!
Igniting the fire
After filling: ignite the appliance with a suitable lighter make sure that:
Never ignite the appliance at a distance closer than 14 cm!
Warning:
Note:
4
24
AFFF: Aqua Fluid Film Foam extinguishers
AR-AFFF: (Alcohol-Resistant Aqueous Film Forming Foam) extinguisher
CO
: Carbon dioxide
2
Protect the appliance from wind and draught in a draughty environment.
Do not move.
Observe local legislation.
Only use outdoors. Should you coincidentally use it indoors then make sure to
only use the appliance in a well ventilated room (25% of the walls should be
open and >60 m
3
).
Only install the appliance on a solid floor or table of non combustible mate-
rial!
Keep the appliance at least 1 meter away from inflammable materials.
Do not change the construction of the appliance!
Only use spare parts which are approved by the manufacturer.
When checking any malfunctioning or when in doubt: extinguish the fire
using the extinguishing tool or using an extinguisher
This appliance is NOT suitable for continuous operation.
Never leave the appliance unattended during operation!
Never leave the appliance when light on!
Only use the type of fuel as specified by the manufacturer in this manual.
Igniting can be done at 14 cm or more from the burner opening.
The fire can be witnesses during igniting process.
DO NOT ignite the appliance if it is in a hot state or damaged.
Be careful! Parts of the appliance- especially outer surface- might become hot
during operation.
Before lighting: take out the burner from its seat and check the secondary
containment chamber in which the burner is seated for spilled ethanol. If spil-
led ethanol is witnessed: remove it.
Only use suitable bio-ethanol with over 95% alcohol, preferred fuel brand
Domestix
Fuel will burn low at the start. Flame might hardly be visible. Allow 10-15
minutes for the flame to reach optimum temperature and visibility.
Avoid drafts
The glass of the appliance might become dark during use. This is normal and
can be cleaned when the fire is extinguished and the appliance has cooled
down.

Publicidad

loading

Este manual también es adecuado para:

Ffb 830Ffb 4242