tbs electronics Powersine Combi PSC2000-12-80 Manual Del Propietário página 13

Factory setting = OFF
Factory setting = ON
1)
Invalid battery type settings can cause serious damage to your batteries and/or connected
battery loads. Always consult your battery's documentation for the correct charge voltage
settings.
2)
When charging and discharging lithium batteries with built-in BMS, please make sure to
correctly size the batteries. Due to the larger Depth of Discharge capabilities of lithium
batteries, it is common to install lithium batteries with a smaller capacity compared lead
based types. It is however important to carefully check if these batteries can still accept the
maximum charge current of the Powersine Combi without tripping its internal BMS relay.
The same applies to the battery's capability to deliver the peak discharge currents that the
Powersine Combi needs to power demanding AC loads. An excessively tripping BMS relay
may over time cause damage to the Powersine Combi.
Models : PSC2000-3500 only
Reserved
Models : PSC2000-3500 only
Bypass remote switch (Bypasses the remote switch
connection when no remote switch is connected)
ON : Remote switch connection terminals are bypassed
OFF : remote switch connection terminals are open. A
remote switch must be connected and switched ON
in order to activate the Powersine Combi. The local
on/off switch on the frontpanel always overrides the
remote switch. So in order to use the remote switch,
the local on/off switch must be in the 'on' or
'charger only' position.
!
CAUTION
!
CAUTION
12