LG DV256K Manual Del Usuario página 9

Installation and Setup
Setting up the Player
The picture and sound of a nearby TV, VCR, or radio
may be distorted during playback. If this occurs,
position the player away from the TV, VCR, or radio,
or turn off the unit after removing the disc.
DVD Player Connections
Depending on your TV and other equipment there are
various ways you can connect the player. Please refer
to the manuals of your TV, stereo system or other
devices as necessary for additional connection
information.
Caution:
You must set the TV Output Select option on the
setup menu to use COMPONENT / PROGRESSIVE
SCAN jack or S-Video jack. (Refer to page 12.)
Video and Audio Connections
to Your TV
Make sure the DVD player is connected directly to the
TV and not to a VCR, otherwise the DVD image could
be distorted by the copy protection system.
Video – Connect the VIDEO OUT jack on the
DVD player to the video in jack on the TV using
the video cable (V).
S-Video: Connect the S-VIDEO OUT jack on the
DVD Player to the S-Video in jack on the TV using
the S-Video cable (S).
Audio – Connect the left and right AUDIO OUT
jacks of the DVD player to the audio left and right
IN jacks on the TV using the audio cables (A).
Do not connect the unit's AUDIO OUT jack to the
phone in jack (record deck) of your audio system.
Component Video – Connect the COMPONENT
/PROGRESSIVE SCAN jacks on the unit to the
corresponding jacks on the TV using an Y P
cable (C).
Note:
If you connect both S-Video and component jack
to your TV, the video may be displayed unstably
on your TV. You should disconnect one of both
connections to solve the problem.
Progressive Scan
• If your television is a high-definition or "digital
ready" television, you may take advantage of
the DVD player's progressive scan output for
the highest possible video resolution.
• Set the Progressive Scan to "On" on the setup
menu for progressive scan signal.
(Refer to page 12)
• Progressive scan does not work with the
analog video connections (yellow VIDEO OUT
jack).
P
B R
9