Publicidad
Installation
B
A
E
A
B
D
C
H
• Use threads sealing tape in all the connections (A).
• Screw the reducing nut (B) to the inlet and outlet pipes.
• Keep open a few seconds the closing valves (C) to clean
and remove any particle from the inlet and outlet
connections before installing the pump.
• Setting a filter is recommended (D) in the inlet pipe.
• Install the flow sensor (E) between the pump and the
outlet piping.
• Fix the pump (F).
• Connect the flow sensor cable to the remote selector (G).
• Set the shut off switch (o) and open the inlet and outlet
valves (H).
• Connect the pump into a grounded power socket (I).
I
F
H
G
OFF (O)
Automatic ( II )
7
ENGLISH
Publicidad
