Fuel System - Weed Eater W25CB Manual De Instrucciones

Ocultar thumbs Ver también para W25CB:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Make adjustments with the unit supported so
the cutting attachment is off the ground and
will not make contact with any object. Hold the
unit by hand while running and making adjust-
ments. Keep all parts of your body away from
the cutting attachment and muffler.
To adjust idle speed:
Start engine and allow to warm up 4- -5
minutes while heavy cutting, or 10- -15
minutes moderate cutting. Allow engine to
idle. Adjust speed until engine runs without
stalling (idle speed too slow).
S Turn idle speed screw clockwise to in-
crease engine speed if engine stalls or dies.
S Turn idle speed screw counterclockwise to
decrease engine speed.
CAUTION:
Perform the following steps af-
ter each use:
S Allow engine to cool, and secure the unit
before storing or transporting.
S Store unit and fuel in a well ventilated area
where fuel vapors cannot reach sparks or
open flames from water heaters, electric
motors or switches, furnaces, etc.
S Store unit with all guards in place. Position
unit so that any sharp object cannot acci-
dentally cause injury.
S Store unit and fuel well out of the reach of
children.
SEASONAL STORAGE
Prepare unit for storage at end of season or if
it will not be used for 30 days or more.
If your unit is to be stored for a period of time:
S Clean the entire unit before lengthy storage.
S Store in a clean dry area.
S Lightly oil external metal surfaces.

FUEL SYSTEM

Under FUELING ENGINE in the OPERA-
TION section of this manual, see message la-
beled IMPORTANT regarding the use of
proper fuel in your engine.
Fuel stabilizer is an acceptable alternative in
minimizing the formation of fuel gum deposits
during storage. Add stabilizer to the gasoline
in the fuel tank or fuel storage container.
Follow the mix instructions found on stabilizer
container. Run engine at least 5 minutes after
adding stabilizer.
If you require further assistance or are unsure
about performing this procedure, contact an
authorized
1- -800- -554- -6723.
STORAGE
ENGINE
S Remove spark plug and pour 1 teaspoon of
40:1, 2-cycle engine oil (air cooled) through
the spark plug opening. Slowly pull the
starter rope 8 to 10 times to distribute oil.
S Replace spark plug with new one of recom-
mended type and heat range.
S Clean air filter.
S Check entire unit for loose screws, nuts,
and bolts. Replace any damaged, broken,
or worn parts.
S At the beginning of the next season, use
only fresh fuel having the proper gasoline to
oil ratio.
OTHER
S Do not store gasoline from one season to
another.
S Replace your gasoline can if it starts to rust.
13
Idle Speed Screw
service
dealer
HELPFUL TIP
During storage of your gas/
oil mixture, the oil will sepa-
rate from the gas.
We recommend that you
shake the gas can weekly
to insure proper blending of
the gas and oil.
or
call

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

W25cfW25cbkW25cfkW25sbW25sfW25sbk ... Mostrar todo

Tabla de contenido