DeWalt DCT411 Manual De Instrucciones página 12

FIG. 5
D
To remove the camera cable, turn the connector clockwise (direction
of arrow).
Additional camera cable and extensions are available at additional
cost. Please contact D WALT Industrial Tool Co., 701 East Joppa
E
Road, Baltimore, MD 21286, call 1-800-4-D
9258) or visit our website www.dewalt.com.
Hook and Magnet
(Fig. 6)
The hook is beneficial for retrieving
cable or wire located in tight
spaces. The magnet is beneficial
for retrieving metal objects in tight
spaces.
To attach the hook or magnet, turn
the knurled part of the camera
counterclockwise until it stops.
Align the hook or magnet with the
gray groove (T) then slide it down until
the tabs (U) at the top of the hook/
magnet are securely in the notches (V)
located in the camera lens.
Turn the knurled part clockwise to lock
the base of the hook and magnet.
Belt Hook (Fig. 7) (Optional Accessory)
NOT suspend tool overhead or suspend objects from the belt hook.
ONLY hang tool's belt hook from a work belt.
ensure the screw (W) holding the belt hook is secure.
IMPORTANT: When attaching or
removing the belt hook, use only
the screw (W) that is provided.
The belt hook (X) can be be
WALT (1-800-433-
E
attached to either side of the
tool using only the screw (W)
provided, to accommodate left-
FIG. 6A
or right- handed users. If the hook is not desired at all, it can be
removed from the tool.
To move belt hook, remove the screw (W) that holds the belt hook in
place then reassemble on the opposite side.
T
OPERATION
U
Installing and Removing the Battery
Pack (Fig. 8)
V
NOTE: Make sure your battery pack is fully charged.
FIG. 6B
To install the battery pack (A) into the tool handle, align the battery
with the rails inside the tool's handle and slide it firmly into the handle
until you hear the lock snap into place.
10
WARNING: To reduce the risk of serious personal injury, DO
WARNING: To reduce the risk of serious personal injury,
FIG. 8
A
FIG. 7
X
W
Y