HoMedics MCS-1000H Manual De Instrucciones E Información De Garantía página 7

DEMO BUTTON
For a brief demonstration of the features of the Massage cushion, press the Demo
button. The unit will briefly go through each function. Once completed, the unit
automatically turns off. The L.E.D. light will blink to indicate active function.
NECK AND BACK SPOT MASSAGE
While the unit is in Kneading massage, press either button to stop and focus the
Shiatsu action in one place. Once the unit is operating in Spot Massage, you may
adjust the mechanism position by holding down either button until the desired
position is reached. The Up Arrow will move the mechanism upwards and the Down
Arrow will move it down. Once you release the button, the mechanism will stop in
that place.
HEAT BUTTON
This massage cushion is equipped with heat in the neck, back, and seat cushion.
For soothing heat, when massage is on, simply press the heat button and the
corresponding red L.E.D. light will illuminate. To deselect, press the button again
and the corresponding L.E.D. light will turn off. For your safety, heat cannot be
turned on if no massage program is selected.
NOTE: When "POWER" button is pressed for first-time use, the moving
mechanism will automatically move to the lowest position before starting a
massage program. After initial use, mechanism will always park at lowest
position. See note below regarding parking.
NOTE: The moving massage mechanism always "parks" or finishes in its lowest
position. It continues to this position after the power has been turned off. If the
electrical supply is interrupted, when power is restored, the mechanism will
"park" or move to its lowest position.
7