Publicidad
Información sobre normativas
HP DeskJet 1200 series cumple los requisitos de producto de las oficinas normativas de su país/región.
En esta sección se tratan los siguientes temas:
Número de modelo normativo
●
Declaración de la FCC
●
Instrucciones del cable de alimentación
●
Aviso para los usuarios de Corea
●
Declaración de cumplimiento de VCCI (Clase B) para los usuarios de Japón
●
Aviso para los usuarios de Japón acerca del cable de alimentación
●
Declaración sobre puestos de trabajo con pantallas de visualización para Alemania
●
Declaración de la emisión sonora para Alemania
●
Aviso Normativo para la Unión Europea
●
Declaración de conformidad
●
Número de modelo normativo
A efectos de identificación reglamentaria, al producto se le asigna un Número de Modelo Reglamentario. No
debe confundirse este número de modelo normativo con los nombres comerciales o los números de producto.
Declaración de la FCC
The United States Federal Communications Commission (in 47 CFR 15.105) has specified that the following
notice be brought to the attention of users of this product.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and the receiver.
●
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
●
Consult the dealer or an experienced radio/TV technician for help.
●
NOTE: If the product has an Ethernet / LAN port with metallic casing then use of a shielded interface cable
is required to comply with the Class B limits of Part 15 of FCC rules.
Modifications (part 15.21)
58
Apéndice A Información técnica
ESWW
Publicidad
