Philips AVENT SCD498 Manual Del Usuario página 11

Connecting the belt clip
1 Insert the small pin on the back of the belt clip into the opening on the back of the parent
unit (1). Turn the belt clip to the left () until it locks into position ('click') (Fig. ).
Disconnecting the belt clip
1 Turn the belt clip to the right (1) and take it out of the opening () (Fig. 5).
Connecting the neck strap
1 Insert the small pin at the end of the neck strap into the opening on the back of the parent
unit (1). Turn the neck strap to the left () until it locks into position ('click') (Fig. 6).
Disconnecting the neck strap
1 Turn the neck strap to the right (1) and take it out of the opening () (Fig. 7).
reset function
This function allows you to reset the parent unit and baby unit to the default settings. You can use
this function if problems occur that cannot be solved by following the suggestions in chapter
'Frequently asked questions'. You have to reset each unit separately.
1 Press and hold the on/off button 3 for  seconds to switch on the unit. (Fig. 11)
 Then immediately press and hold the volume down (-) button until the appliance
beeps. (Fig. 8)
The unit has now been reset to the default factory settings.
,
Now do the same for the other unit.
Default settings
Parent unit
- Loudspeaker volume: 1
- Microphone sensitivity: 3
Baby unit
- Loudspeaker volume: 3
- Nightlight: off
Cleaning and maintenance
Do not immerse the parent unit and the baby unit in water and do not clean them under the tap.
Do not use a cleaning spray and/or liquid cleaners.
1 Unplug the baby unit if it is connected to the mains and take the parent unit out of the
charger.
 Clean the parent unit and the baby unit with a damp cloth.
Storage
You can use the travel pouch to store the baby monitor while you travel.
,
When you are not going to use the baby monitor for some time, remove the batteries and
,
store the parent unit, the baby unit and the adapters in the travel pouch supplied.
Environment
Do not throw away the appliance with the normal household waste at the end of its life, but
,
hand it in at an official collection point for recycling. By doing this, you help to preserve the
environment (Fig. 9).
All manuals and user guides at all-guides.com
EngliSh
11