Publicidad
Idiomas disponibles
Idiomas disponibles
Question
Why does the parent unit
react too quickly to other
sounds?
Why does the parent unit
react slowly to the baby's
crying?
Why do the batteries of
the baby unit run low
quickly?
Why does the charging
time of the parent unit
exceed 8 hours?
The specified operating
range of the baby monitor
is 300 metres/900 feet.
Why does my baby
monitor manage a much
smaller distance than that?
Why is the connection lost
every now and then? Why
are there sound
interruptions?
What happens during a
power failure?
Is my baby monitor secure
from eavesdropping and
interference?
All manuals and user guides at all-guides.com
Answer
The microphone sensitivity level of the baby unit may be set too
low. Increase the microphone sensitivity level with the SENSITIVITY
button on the parent unit.
The baby unit and the parent unit may be out of range of each
other. Reduce the distance between the units.
The baby unit also picks up other sounds than those of your
baby. Move the baby unit closer to the baby (but observe the
minimum distance of 1 metre/3 feet).
The microphone sensitivity level of the baby unit may be set too
high. Decrease the microphone sensitivity level with the
SENSITIVITY button on the parent unit.
The microphone sensitivity level of the baby unit may be set too
low. Increase the microphone sensitivity level with the SENSITIVITY
button on the parent unit.
The microphone sensitivity level of the baby unit may be set too
high, which causes the baby unit to transmit more often. Decrease
the microphone sensitivity level with the SENSITIVITY button on
the parent unit.
The volume on the baby unit may be set too high, which causes the
baby unit to consume a lot of energy. Decrease the volume of the
baby unit.
Perhaps you have switched on the nightlight. If you want to use the
nightlight, we advise you to run the baby unit on mains power.
The parent unit may be switched on during charging. Switch off the
parent unit during charging.
The specified range is only valid outdoors in open air. Inside your
house, the operating range is limited by the number and type of
walls and/or ceilings in between. Inside the house, the operating
range is up to 50 metres/150 feet.
The baby unit and the parent unit are probably close to the outer
limits of the operating range. Try a different location or decrease the
distance between the units. Please note that it takes about 30
seconds each time before a connection between the units is
established.
If the parent unit is sufficiently charged, it continues to operate
during a power failure, both inside and outside the charger. If there
are batteries in the baby unit, it will automatically switch to battery
operation in case of power failure.
The DECT technology of this baby monitor guarantees no
interference from other equipment and no eavesdropping.
EngliSh
1
Publicidad
