Rotel T11V02 Manual De Instrucciones página 11

English
Troubleshooting
Most difficulties in audio systems are the result of incorrect connections, or
improper control settings. If you encounter problems, isolate the area of the
difficulty, check the control settings, determine the cause of the fault and
make the necessary changes. If you are unable to get sound, refer to the
suggestions for the following conditions:
Power Indicator Is Not Illuminated
The power Indicator should be illuminated whenever the unit is plugged
into the wall power outlet and the power button is pushed in. If it does not
light, test the power outlet with another electrical device, such as a lamp.
Be sure the power outlet being used is not controlled by a switch that has
been turned off.
No Sound
Check the cables between the output and the pre-amplifier inputs, be sure
they are connected properly. Refer to Fig. 3.
Cannot Tune to DAB/DAB+ Preset Station
Some stations may become unavailable and will be displayed in the Station
List with a "?" character in front of the station name. These stations are no
longer broadcasting or received by the T11V02 unit. Presets that are set to
these stations will not function and if selected the T11V02 unit will display
the DAB menu. To remove stations no longer transmitting use the PRUNE
function in the DAB Menu. This will remove these stations from the Station
List and from the Preset list.
Specifications
FM Tuner FM Tuner
Usable Sensitivity Usable Sensitivity
50dB Quieting Sensitivity 50dB Quieting Sensitivity
Signal to Noise Ratio (at 65 dBf) Signal to Noise Ratio
MONO
STEREO
Harmonic Distortion Harmonic Distortion (at 65 dBf)
MONO
STEREO
Frequency Response Frequency Response
Stereo Separation Stereo Separation
(100Hz/1kHz)
Output level Output level
Antenna Input Antenna Input
DAB Tuner DAB Tuner
Sensitivity Sensitivity
Tuning Range Tuning Range
Audio Data Rate Audio Data Rate
Frequency Response Frequency Response
Analog Output Analog Output
Antenna Input Antenna Input
General General
Power Consumption Power Consumption
Standby Power Consumption Standby Power Consumption
BTU (at 5 watts) BTU
Power Requirements (AC) Power Requirements
USA:
Europe:
Dimensions (W x H x D) Dimensions
Front panel height Front panel height
Weight Weight (net)
All specifications are accurate at the time of printing.
Rotel reserves the right to make improvements without notice
Rotel and the Rotel Hifi logo are registered trademarks of The Rotel Co.,
Ltd. Tokyo, Japan.
11
22.2 dBf
27.2 dBf (mono)
63 dBf
60 dBf
0.2%
0.3%
10Hz - 15kHz, ± 3dB
40dB/ 37dB
1.0 V
75 ohms F connector
-80 dBm
Band III (174 - 240MHz)
224kbps (Max)
20 - 20k Hz +/- 1.0 dB
2.1V at 0 dBFS
75 ohms F connector
10 watts
＜ 0.5 watts
17 BTU/h
120V, 60Hz
230V, 50Hz
430 x 73 x 330 mm
(17 x 2 7 / x 13 in)
8
60 mm
4.3 kg (9.48 lbs)