Cleaning And Storage - JOCCA 5503 Manual De Instrucciones

20-EN
Nozzle of 2 positions (N), for hard floors and carpets:
Position 1:
Extended bristles for hard floors. Press the tab of the nozzle (M)
so that the following symbol goes to the down position:
The lower brush of the nozzle will be
opened.
Position 2:
Contracted bristles to clean carpets. Press the tab of the nozzle
(M) so that the following symbol goes to the down position:
The inside brush of the nozzle will be
collected.
Tube of the narrow nozzle with brush (S):
Suitable for cleaning radiators, corners, borders, boxes, etc..
-To open the brush, turn it as shown by the arrow on this
accessory.
-To gather it and work only with the narrow nozzle, proceed in
reverse.
Small nozzle (T):
For cleaning of curtains, shelves, books, lamps and other delicate
items.
INSTRUCTIONS FOR USE
1.Before connecting the appliance, unroll the wire to avoid over
heating. Assemble the vacuum cleaner according to the previous
ASSEMBLING explanations. Then plug the appliance into the
mains electricity supply.
2.Press the On / Off button (G): the vacuum cleaner will begin to
operate for you the vacuum clean any area.
NOTE: You can adjust the vacuum intensity by using the vacuum
adjuster (A). For higher intensity leave the adjuster closed and to
obtain a lower intensity open the
3.Once you have finished cleaning, please unplug the
appliance.
4.Removing of the hose, extension tube and cleaning
accessories:
-To remove the accessories, pull them hardly to separate from
the extension tube. To release the extension tube of the hose,
pull both parts to the contrary.
-To remove the hose, turn slightly the edge fixed to the motor
body to the left till the position LOOSE.
OFF POSITION:
-In the back side of the vacuum cleaner you can find a supporting
stand (R) where you can fit the nozzle when the device is not
used and off.
-For this, turn off the device and unplug it. Fit the tab placed on
the back side of the tube of the nozzle on this supporting stand.

CLEANING AND STORAGE

-Please unplug the appliance from the electricity supply when
not being used, and before attempting to clean the same.
-Do not use abrasive detergents or products that may damage
the appliance.
-NEVER INMERSE THE APPLIANCE IN WATER OR ANY OTHER
LIQUID.
-Use a damp cloth or sponge to clean the outside of the
appliance.
-Keep the appliance in a dry and safe place once you finish to
use it.
EN-21
adjuster.