Publicidad
OP1
OP2
OP3
(2)
(1)
OP4
26
(1)
A
B
(3)
(4)
English
8. Operation
■ STARTING ENGINE
WARNING
The cutting head will start rotating upon the engine
starts.
1. Rest the unit on a flat, firm place. Keep the cutting
head off the ground and clear of surrounding objects
as it will start rotating upon starting of the engine.
2. Push the primer pump several times until overflown
fuel flows out in the return tube. (OP1)
3. Move the choke lever to the closed position. (OP2)
(2)
(1) Choke lever
(3) B: the open position
4. Set the ignition switch to the "start" position. (OP3)
(1) Ignition switch
(3)
(3) Start
5. While pulling the throttle lever, push the throttle set
button, and release the throttle, then the throttle
lever is in to the "Start position". (OP3)
6. While holding the unit firmly, pull out the starter rope
quickly until engine fires. (OP4)
IMPORTANT
• Avoid pulling the rope to its end or returning it by
releasing the knob. Such actions can cause starter
failures.
7. Move the choke lever to the open position (OP2).
And pull out the starter rope quickly to restart
engine. (OP4)
8. Allow the engine to warm up for several minutes
before starting operation.
1. When restarting the engine immediately after
stopping it, leave the choke open (OP2) and push
the primer pump several times (OP4).
2. Overchoking can make the engine hard to start due
to excess fuel. When the engine failed to start after
several attempts, open the choke and repeat pulling
the rope, or remove the spark plug and dry it.
(2) A: the closed position
(2) Stop
(4) Throttle set button
NOTE
Publicidad
