Publicidad
Idiomas disponibles
Idiomas disponibles
F E AT U R E S - O P E R AT I O N S
TECHNICAL SPECIFICATIONS
• Amps: 12.5
• Wattage: 1500W (+5% –10%)
• Working voltage: 120V AC/60Hz
OPERATING INSTRUCTIONS
1. Carefully remove your heater from the box. Please
save the carton for off-season storage.
2. Place heater on a firm, level surface.
3. Plug heater into a standard outlet. Once plugged in,
the Power Light will illuminate.
NOTE: Avoid overloading your circuit by not using other
high wattage appliances in the same outlet. At 1500
watts, this unit draws 12.5 Amps.
4. Press the Power Button ( ) to start operation.
Mode Control
Press the MODE Button to select the desired heat settings.
Each press of the button will cycle through the below
settings and the selected setting will appear on the LCD:
HI - HIGH Heat
The heater will run continuously at 1500W.
LO - LOW Heat
The heater will run continuously at 750W.
EC - Eco-Smart
TM
The heater will now cycle between high (at 1500W) and
low (at 750W) heat settings to provide heat.
NOTE: To shut unit off at any time, press the Power
Button ( ) until LCD Display goes OFF.
Thermostat Control
The next press of the Mode Button will activate the
thermostat setting, and the LCD will display "80°" as the
default temperature setting.
Your heater is equipped with a digital thermostat that
allows you to set your heater to a precise comfort level
(65 °F-85 °F) by pressing the Up (
Button on the control panel. The LCD Display will show
the selected temperature reading. When the preset
temperature is reached, the heater will shut off. When
the room temperature drops below the preset
temperature, the heater will automatically turn on again
to maintain the preset temperature level.
Your heater is equipped with FrostProtect™. The
heater will turn on automatically when the room
temperature drops below 40°F. To activate FrostProtect™,
press the Down (
"40" and the FrostProtect™ icon ( ) will appear
on the LCD Display.
NOTE: To shut unit off at any time, press the Power
Button ( ) until LCD Display goes OFF.
NOTE: It is normal for the heater to cycle ON and OFF as
it maintains the preset temperature. To prevent the unit
from cycling, you need to change the thermostat setting.
The digital thermostat has memory; it will remember the
last temperature setting before the heater is turned off.
However, if the heater is unplugged, the digital
thermostat will no longer remember the previous
temperature setting. You will need to reset the digital
thermostat if the heater is unplugged.
Figure 1
) and Down (
)
FrostProtect™ Setting
) button until the LCD Display show
CONTROL PANEL
B
A
E
A. POWER BUTTON
B. LCD DISPLAY
C. POWER LIGHT
C
D
D. MODE BUTTON
E. UP/DOWN BUTTON
Publicidad
