HoMedics brethe AR-NC02 Manual De Instrucciones E Información De Garantía página 6

Fig. 10
Fig. 11
TABS TABS
Fig. 12
Fig. 13
3. Remove the Nano-Coil filter from
the unit by grasping the center
handle and pulling out from the
center hub. See Fig. 10
4. Use the brush attachment with your
vacuum cleaner. Run the attachment
along both sides of the Nano-Coil
filter, taking care not to dislodge the
combs. See Fig. 11
5. Replace the Nano-Coil filter.
Make sure to align the center of the
filter handle with the center hub.
Filter handle should be vertical.
Be sure the post on the center hub
comes through the hole on the filter's
handle. See Fig. 10
6. Place the tabs at the bottom of the
grill plate into the base of the unit.
See Fig. 12
7. Hold engaged bottom of the grill
plate in place and push the top of the
grill plate back toward the unit until
the release tabs at the top of the grill
click back into place. See Fig. 13
DO NOT USE WATER OR ANY
HOUSEHOLD CLEANERS OR
DETERGENTS TO CLEAN THE
NANO-COIL FILTER OR
PRE-FILTER
1 0
Pre-Filter
Fig. 14
Fig. 15
Fig. 16
1. Open the rear grill by gently pushing
the release tabs toward the outside
of the unit. See Fig. 14
2. Pull the grill away from the body until
the tabs at the bottom of the grill
plate easily slide away from the unit.
See Fig. 15 & 16
11