Descargar Imprimir esta página

HoMedics brethe AR-NC02 Manual De Instrucciones E Información De Garantía página 7

Publicidad

Idiomas disponibles

Idiomas disponibles

3. If you are using the VOC filter, remove
it by sliding out of the 4 clips.
See Fig. 17
4. Remove the pre-filter by gently pulling
it off and away from the 4 posts. See
Fig. 18
Fig. 17
5. Use the brush attachment with your
vacuum cleaner. Run the attachment
along both sides of the pre-filter.
See Fig. 11
6. Replace the pre-filter by pushing the
4 loops of the filter onto the 4 posts
of the grill. See Fig. 18
Fig. 18
7. If you are using the VOC filter, put it
back in and secure with 4 clips.
See Fig. 17
8. Place the tabs at the bottom of the
grill plate into the base of the unit.
See Fig. 19
Fig. 19
1 2
Fig. 20
Clean Filter Indicator
This air cleaner is equipped with a CLEAN FILTER indicator to let you know when it
is time to clean the Nano-Coil filter, about every 732 hours of use. When the Nano-
Coil filter is ready to be cleaned, the CLEAN FILTER indicator will light up on the
control panel.
Once the Nano-Coil filter has been cleaned, press and hold the CLEAN FILTER button
until it beeps to reset the filter indicator.
We recommend replacing your VOC filter, if you choose to use it, when you replace
your Nano-Coil filter (about every 18 months, with regular maintenance).
To purchase a Nano-Coil replacement filter, model # AR-NCFL1, go back to the retailer
(where you purchased your air cleaner) or visit www.homedics.com. Replacement
VOC filter, model # PP-ARNC01VOC, can also be purchased
at www.homedics.com.
9. Hold engaged bottom of the grill plate
in place and push the top of the
grill plate back toward the unit until
the release tabs at the top of the grill
click back into place. See Fig. 20
13

Publicidad

loading