Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. D
13
2
Bit and Bit Holder
WARNING: Burn Hazard. ALWAYS wear gloves when
changing bits. Accessible metal parts on the tool and
bits may get extremely hot during operation. Small
bits of broken material may damage bare hands.
The rotary hammer can be fitted with various chisel bits
depending on the desired application. Use sharp drill
bits only.
Inserting and Removing SDS MAX Bits
(Fig. E)
1. Insert bit in the bit holder 6 and apply downward
pressure while rotating to secure the bit into place. The
bit shank must be clean.
2. Ensure the bit is properly engaged.
nOTE: The bit needs to move several centimeters in and
out of the bit holder
when properly engaged.
6
Fig. E
6
3. To remove the bit, pull back the locking sleeve
pull the bit out.
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the Battery Pack
(Fig. F)
nOTE: For best results, make sure your battery pack is
fully charged.
To install the battery pack
8
align the battery pack with the rails inside the tool's battery
cage and slide it in until the battery pack is firmly seated.
Ensure that it does not disengage.
3
7
7
and
into the tool's battery cage,
To remove the battery pack from the tool, press the release
button
9
and firmly pull the battery pack out of the tool
handle. Insert it into the charger as described in the charger
section of this manual.
Fig. F
9
Proper Hand Position (Fig. G)
WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the mounted
side handle
2
, with the other hand on the main handle
Fig. G
2
SHOCKS Active Vibration Control®
System
For best vibration control, hold the tool as described in
Proper Hand Position and apply just enough pressure so
the damping device on the main handle is approximately
mid stroke. The hammer only needs enough pressure to
engage the active vibration control. Applying too much
pressure will not make the tool actuate faster and active
vibration control will not engage.
D
WALT Tool Tag Ready (Fig. A)
e
Optional Accessory
Your hammer comes with mounting holes
fasteners for installing a D
WALT Tool Tag. You will need a
e
T15 bit tip to install the tag. Only use the screws provided.
The D
WALT Tool Tag is designed for tracking and locating
e
professional power tools, equipment, and machines using
the D
WALT Tool Connect™ app. For proper installation
e
and use of the D
WALT Tool Tag refer to the D
e
Tag manual.
English
8
5
.
5
12
and
WALT Tool
e
9
Publicidad
