Publicidad
Idiomas disponibles
Idiomas disponibles
* i.p.m. = Impact per minute.
Avoid repeatedly depressing the switch
when the bolts and screws are securely
fastened.
Not doing so may cause a delay in
rotation starting, or the Impact Power
mode display to flash and prevent rotation
from starting for circuit protection.
(2) LED light
Pressing the
gles the LED light on and off.
The light illuminates with
very low current, and it does
not adversely affect the per-
formance of the driver during
use or its battery capacity.
CAUTION:
• The built-in LED light is designed to illu-
minate the small work area temporarily.
• Do not use it as a substitute for a regu-
lar flashlight, since it does not have
enough brightness.
This product has the built-in LED light.
This product is classified into "Class 1 LED
Product" to IEC (EN) 60825-1:2001.
Class 1 LED Product
Caution : DO NOT STARE INTO BEAM.
Use of controls or adjustments or performance
of procedures other than those specifi ed herein
may result in hazardous radiation exposure.
(3) Overheat warning lamp
Off
Illuminated:
(normal
Overheat
operation)
(motor)
Indicates operation has
been halted due to motor
or battery overheating.
To protect the motor or battery, be sure to
note the following when carrying out this
operation.
• If the motor or battery becomes hot, the
protection function will be activated and
the motor or battery will stop operating.
The overheat warning lamp on the
control panel illuminates or flashes
when this feature is active.
EY7546_EY7547_EY7550_EY7551_US.indb 12
EY7546_EY7547_EY7550_EY7551_US.indb 12
• If the overheating protection feature
• Avoid using the tool in a way that
• If the tool is operated continuously
but ton tog-
• If the tool is used in cold-temperature
• The performance of the EY9L42
• The ambient temperature range is
• Use the charger at temperatures
(4) Battery low warning lamp
Flashing:
Overheat
(battery)
Off (normal
operation)
Excessive (complete) discharging of
lithium ion batteries shortens their service
life dramatically. The driver includes a
battery protection feature designed to
prevent excessive discharging of the
battery pack.
• The battery protection feature activates
- 12 -
activates, allow the tool to cool
thoroughly (at least 30 minutes). The
tool is ready for use when the overheat
warning lamp goes out.
causes the overheating protection
feature to activate repeatedly.
under high-load conditions or if it is
used in hot-temperature conditions
( s u c h a s d u r i n g s u m m e r ) , t h e
overheating protection feature may
activate frequently.
conditions (such as during winter) or if
it is frequently stopped during use, the
overheating protection feature may not
activate.
deteriorates significantly at and below
10°C due to work conditions and other
factors.
between 0°C (32°F) and 40°C (104°F).
If the battery pack is used when the
battery temperature is below 0°C
(32°F), the tool may fail to function
properly.
between 0°C and 40°C, and charge the
battery at a temperature similar to that
of the battery itself. (There should be no
more than a 15°C difference between
the temperatures of the battery and the
charging location.)
Flashing (No charge)
Battery protection
feature active
immediately before the battery loses its
2012-10-10 10:17:44
2012-10-10 10:17:44
Publicidad
