Publicidad
Idiomas disponibles
Idiomas disponibles
1English1
WHEN PUTTING TOOLS INTO SERVICE
WARNING
Always install, operate, inspect and maintain this product in accordance with all
applicable standards and regulations (local, state, country, federal, etc.).
Always use clean, dry air at 90 psig (6.2 bar/620 kPa) maximum air pressure at
the inlet, unless a higher pressure rating is specified on the tool. Exceeding the
maximum rated pressure shown on the tool may result in hazardous situations
including excessive speed, rupture, or incorrect output torque or force.
Always turn off the air supply, bleed the air pressure and disconnect the air
supply hose before installing, removing or adjusting any accessory on this tool,
or before performing any maintenance on this tool or any accessory.
Be sure all hoses and fittings are the correct size and are tightly secured.
Install a properly sized safety air fuse upstream of hose and use an anti-whip
device across any hose coupling without internal shut-off, to prevent hose
whipping if a hose fails or coupling disconnects.
Ensure an accessible emergency shut off valve has been installed in the air
supply line, and make others aware of its location.
Use only proper cleaning solvents to clean parts. Use only cleaning solvents which
meet current safety and health standards. Use cleaning solvents in a well ventilated
area.
Keep clear of whipping air hoses. Shut off the compressed air before approaching a
whipping hose.
Keep work area clean, uncluttered, ventilated and illuminated.
Do not use damaged, frayed or deteriorated air hoses and fittings.
Do not lubricate tools with flammable or volatile liquids such as kerosene, diesel
or jet fuel. Use only recommended lubricants.
Do not use quick disconnect couplings at tool. When universal twist couplings are
used, lock pins must be installed. Never direct air at yourself or others.
Do not remove any labels. Replace any damaged label.
English
-4
Publicidad
