Husqvarna 96784490102 Manual Del Operador página 13

CONTROLS
Ignition Switch
The ignition switch is placed on the control panel
and is used to start and stop the engine.
Service Meter
The service meter displays the total operating
time with the blade activated.
At 50 hour intervals of operation, an oil can
icon shows and stays on for two hours before
an automatic reset occurs. To manually reset
the meter, turn the key off and on five times at
one second intervals. To service the engine and
mower, see the Service Journal of this manual.
Blade Switch
To engage the mower deck, pull the knob out;
mower blades are disengaged when the knob is
pressed down.
Choke Control
The choke control is used for cold starts to
provide the engine with a richer fuel mixture. For
cold starts, pull the control up.
To Adjust The Seat
A
1. Lift seat up and remove seat adjustment knob
(A).
2. Loosen seat adjustment knob (B).
IMPORTANT INFORMATION
seat adjustment knob (B).
3. Move seat to necessary position, line up the
hole in the seat pan for seat adjustment knob
(A) with the hole in the seat.
4. Install and tighten seat adjustment knob (A).
5. Tighten seat adjustment knob (B).
B
Do not remove
13