Publicidad
Idiomas disponibles
Idiomas disponibles
20 / EN
IV. INSTALLING YOUR HEATER
Heater location
For optimal performance, place the heater as close as possible to the points of
use (we recommend not more than a 5-meter distance). This will minimize the
loss of heat and provide hot water faster at the point of use.
•
It is an appliance that must be installed vertically to operate properly. When
the installation is finished and before filling it with water and switching on
the power supply, make sure it is effectively vertically mounted, using a
testing instrument (such as a bubble level).
•
Install your water heater so that the control panel is not obstructed, to
facilitate its maintenance and operation leave a free space of at least 50
cm for access to the electrical parts.
•
The water heater's location should be as practical as possible, near the
areas where hot water is used in order to avoid heat loss or freezing in
areas of extreme cold.
•
The heater requires protection against the rain, preferably a roof at a
minimum of 80 cm from the heater cover.
•
This water heater can be installed inside or in enclosed spaces, because
it does not require ventilation.
•
The heater must be perfectly fixed to avoid movement during earthquakes
and/or tremors, in order to prevent it falling from its position. It must also
be protected by a roof or niche to avoid direct contact with the rain.
•
The heater must be mounted with its support, anchors and hooks
(included).
•
Generally, for different wall types, especially walls with bricks, perforated
blocks, or blocks with limited firmness, this mounting must be checked for
safety. The wall mounting hooks must be able to support a weight three
times the weight of the heater full of water.
•
Do not place objects under the water heater, to avoid damages.
Multiple position installation
The product can be installed vertically and horizontally (Fig. 2). For the horizontal
installation, turn the appliance clockwise so that the water pipe is at the left
(cold water pipe on the lower part). Make sure is effectively vertically mounted,
using a testing instrument (such as a bubble level).
Publicidad
