Worx WG260E.5 Manual Original página 12

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for cutting and
trimming hedges and bushes in domestic use.
WARNING! Do not use the product
without attaching the guard and
front handle.
ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Assembling the safe guard
Assembling the Front Handle
NOTE: Handle screws should be
facing the protective shield. If the
handle is assembled incorrectly,
the tool will not power on.
12
Installing and Removing the
battery pack
Charging the battery pack
Your battery pack is
UNCHARGED, you must charge
before use.
More details can be found in
WA3760 (for WG259E/WG260E)
or WA3860 (for WG259E.5) or
WA3880 (for WG260E.5) manual
OPERATION
Starting and stopping
Top cutting
WARNING: If any parts
are missing, damaged
or broken, do not operate your
hedge trimmer until all damaged
parts have been replaced or
repaired. Failure to do so could
result in serious personal injury.
DO NOT USE WITHOUT FRONT
HANDLE AND SAFETY GUARD.
Cordless Hedge Trimmer
Side cutting
Lubricating the Cutting Blade
NOTE: It is important to use
only the recommended standard
lubricating oil (WD-40) to avoid
damage to the blade.
HOW TO USE YOUR HEDGE
TRIMMER
Note that the front switch lever can be
activated on three sides, giving you many
FIGURE
choices for a comfortable grip. Before cutting
an area, inspect it first and remove any
foreign objects that could become thrown
See Fig.
or entangled in the blades. Always hold the
A
trimmer with both hands and with the blade
away from you before turning it on.
When trimming new growth, use a wide
See Fig.
sweeping action so that the stems are fed
B1, B2,
directly into the blade. (See Fig. E1& E2)
B3
Allow the cutting blades to reach full speed
before cutting. When operating, keep the
See Fig.
cutting blades away from people and objects
C
such as walls, large stones, trees, vehicles, etc.
If the blade stalls, immediately stop the
trimmer. Release the two Switch Levels (5 &
6) before attempting to clear jammed debris
from the cutting blades.
Wear gloves when trimming thorny or prickly
growth.
Do not attempt to cut stems that are too thick
for the cutting blade.
TOP CUTTING
Use a wide sweeping motion (See Fig. E1). A
slight downward tilt of the cutting blades in
See Fig.
the direction of motion gives the best cutting
D1, D2
results.
SIDE CUTTING
When trimming the sides of the hedge, begin
at the bottom and cut upwards (See Fig.
E2), tapering the hedge inward at the top.
This shape will expose more of the hedge,
See Fig.
resulting in a more uniformed growth.
E1
See Fig.
E2
See Fig.
F
EN