Publicidad
Idiomas disponibles
Idiomas disponibles
TECHNICAL DESCRIPTION
There are four Eemax Mini tank models, a 1.5 gallon, a 2.5 gallon, a 4 gallon
and a 6 gallon model. The pressure vessel (water tank) is welded, glass lined
steel and is equipped with an anode rod.
The water heater is equipped with a thermostat and a high limit temperature
switch. A temperature/pressure relief valve is supplied with the unit.
INSTALLATION INSTRUCTIONS
EMT 1 - EMT 2.5 - EMT 4 - EMT 6
The installation must be completed by a licensed professional. All state and
local codes must be adhered to. The manufacturer will not be liable for any
damages because of failure to comply with these installation instructions or
because of improper installation performed by an unqualified installer.
CHOOSE A LOCATION that allows ease of access for maintenance or
servicing, ideally installed at least 8" to 9" from the ceiling (inside top of
cabinet) or any adjacent walls.
WALL MOUNTING
Fasten the supplied mounting bracket to the wall. Use screws that are
suitable for the wall material and the weight of the water heater filled to
capacity (EMT 1 = 25 lbs. - EMT 2.5 = 37 lbs. - EMT 4 = 52 lbs. - EMT 6 =
80 lbs.). Hang the water heater on the bracket and pull downwards on the
water heater to insure that both "fingers" of the bracket are seated in the
mounting slots. Confirm your water piping orientation (hot and cold) before
wall mounting. ONLY INSTALL IN VERTICAL POSITION.
Heater can sit on the floor. Confirm water piping orientation before finalizing
on floor. ONLY INSTALL IN VERTICAL POSITION! EMT models can be installed
under the sink.
55
Page 6 of
Publicidad
