Attaching And Removing The Vacuum Bag - MTD BV3100 Manual De Instrucciones

Screw
Self-Tapping Screw
Removing
WARNING: To prevent serious personal injury,
stop the engine and allow the impeller to stop
before attaching or removing tubes.
1. Remove the 2 (two) self-tapping screws from either
side of the housing.
2. Remove the 2 (two) screws and nuts holding the
blower/vacuum tube on the housing (Fig. 1).
NOTE: Keep the hardware in a safe place for future use.
3. Remove the blower/vacuum tube from the motor
housing.
4. Replace the blower/vacuum tube before use.
Screw Self Tapping
and Nut Screw
GB6
ASSEMBLY INSTRUCTIONS
Motor Housing
Nut
Blower/Vacuum
Tube
Fig. 1
Screw and Nut
Fig. 2

ATTACHING AND REMOVING THE VACUUM BAG

Attaching
1. Attach the vacuum bag to the vacuum bag hook on
the blower/vacuum tube (Fig. 3).
2. Slide the vacuum bag tube over the debris exhaust
tube on the housing. Push the tube until the latching
tabs on both sides click into place, securing the bag
on the unit (Fig. 4).
Removing
1. Press the latching tabs on both sides of the vacuum bag
tube and pull the vacuum bag from the unit (Fig. 5).
2. Detach the vacuum bag from the vacuum bag hook.
Latching Tabs
Vacuum Bag Hook
Fig. 3
Debris Exhaust Tube
Vacuum Bag Tube
Vacuum Bag
Zipper
Fig. 4
Latching Tabs
Fig. 5