Publicidad
Idiomas disponibles
Idiomas disponibles
All operating elements and connections described
can be found on the fold-out page 3.
1 Operating Elements and Connections
1 Transmitting antenna
2 Power switch
3 LC display; indicates the transmission channel and
the charging status of the batteries during opera-
tion
4 Microphone connection (4-pole mini XLR jack)
5 Key
for channel selection "up" (in the channel
adjusting mode) and for activating the lock function
(in the lock mode)
6 Key
for channel selection "down" (in the channel
adjusting mode) and for deactivating the lock func-
tion (in the lock mode)
7 Key SET
with the unit not locked:
to recall and to exit the adjusting modes for chan-
nel and lock function → chapters 5.1 and 5.2.1
with the unit locked:
to recall and to exit the adjusting mode for the
lock function → chapter 5.2.2
8 Gain control; for matching the input sensitivity turn
the control with the supplied adjusting key
9 Battery compartment for two 1.5 V batteries of size
AA (R6)
10 Cover of the battery compartment
2 Important Notes
The unit corresponds to all relevant directives of the
EU and is therefore marked with
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity, and heat (admissible ambient temperature
range 0 – 40 °C).
G
For cleaning only use a dry, soft cloth, by no means
chemicals or water.
G
No guarantee claims for the unit and no liability for
any resulting personal damage or material damage
will be accepted if the unit is used for other purposes
than originally intended, if it is not correctly operated
or not repaired in an expert way.
If the unit is to be put out of operation defini -
tively, take it to a local recycling plant for a
disposal which is not harmful to the environ-
ment.
Do not put exhausted batteries/defective rechargea-
ble batteries into the household rubbish but take
them to a special waste disposal (e. g. collective con-
tainer at your retailer).
3 Applications
This multifrequency pocket transmitter is provided for
connecting a headband microphone, a Lavalier micro-
phone, or an instrument microphone. In combination
with the multifrequency dual receiver US-902D / 5 from
JTS it makes up a wireless audio transmission system.
The transmission channel can be selected as desired
among 16 channels in the UHF frequency range of
518 – 542 MHz.
case, an artificial leather bag for fastening the trans-
mitter to your clothes, and the Lavalier microphone
CM-501.
3.1 Conformity and Approval of the transmitter
Herewith, MONACOR INTERNATIONAL declare that
the unit PT-920B / 5 is in accordance with the basic
requirements and the other relevant regulations of the
directive 1999 / 5 / EC. The declaration of conformity
can be found in the Internet via the JTS home page
(www.jts-germany.de).
This unit may be operated in the following countries:
DE
In the Federal Republic of Germany, the pocket trans-
mitter requires a frequency assignment (for which a
fee is charged).
In other countries, it is necessary to apply for a cor -
responding approval. Prior to operating the pocket
transmitter outside Germany, please contact the
MONACOR subsidiary or the corresponding authorities
of the respective country. Links to the national authori-
ties can be found via the following Internet address:
www.cept.org
→ ECC
→ Topics
.
→ Short Range Devices (SRD) and other R&T TE
→ EFIS and National Frequency Tables
4 Power supply
G
G
1) Open the velcro fastener and take the transmitter
2) Remove the cover (10) of the battery compartment.
3) Insert two 1.5 V batteries of size AA (R6) with the
4) Replace the cover.
The transmitter is supplied with a stable transport
sub-classes
Insert only batteries of the same type and always
replace all batteries.
If the unit is not used for a longer period (e. g. more
than a week), remove the batteries. Thus, the unit
will not be damaged in case of battery leakage.
out of the belt bag.
This will allow access to the battery compartment (9).
positive and negative connections as indicated in
compartment.
7
Publicidad
