Publicidad
Idiomas disponibles
Idiomas disponibles
EN – GENERAL ASSEMBLY INSTRUCTIONS
IMPORTANT SAFETY INFORMATION
•
Check the content of the package in parts list on page 2 and make sure that all parts are in order. Do not use damaged
or faulty parts.
•
Read all instructions before installing the equipment. When you are unsure about any part of the installation process, ask
a professional technician for help.
•
When tightening the screws, be careful to avoid stripping the thread.
•
Do not install on a damp or otherwise damaged wall. The assembly material supplied in the package is designed to be
mounted on a wall of bricks and concrete. For installation on walls made of other materials consult a professional.
•
Never install or use this product if there are signs of damage.
•
The edges of the equipment may cause injury if they are handled improperly.
•
This device is not designed for assembly or handling by small children, or persons, who have not been specifically
instructed unless supervised by a responsible person to ensure safety during handling or installation. Children should
be supervised to ensure that they do not interfere with the equipment. Do not allow children to hang on the equipment
or otherwise handle it. Otherwise, there is a danger of serious injury. Never insert your fingers or other objects into the
mechanism of the equipment. It could cause personal injuries or property damage.
•
The product contains small parts that can pose a choking hazard when inhaled or swallowed. Keep these parts out of
reach of children!
Note: Specifications and design are subject to change due to improvements without notice.
LIST OF SUPPLIED PARTS
A
Safety glass shelf
B
Aluminium support (long)
C
Aluminium support (bottom)
D
Aluminium support (cover)
E
Plastic support (middle)
INSTALLATION
Attachment of the wall plate to the wall made of bricks or concrete
Mark on the wall the position of 4 holes for attachment of the wall plate. Use the plate L as a template (Fig. 1). Using masonry
drill (8 mm) pre-drill holes at least 5 cm deep and insert a plastic anchor K in each. Make sure that the plastic anchor is entirely
inserted and level with the wall. Attach the plate to the wall using four screws J and washers N, see Fig. 2.
Shelf assembly
The shelf assembly is thoroughly shown in picture 3A, or 3B depending whether you bought model SHO 1180 or 1181.
Attachment of the assembled shelves to the wall plate
After you assemble the shelf, attach it to the wall plate and tighten using two connecting screws
again, depending on the particular model.
Congratulation, the installation is done. We wish you a pleasant experience when watching movies and shows from a player
or a DVB receiver placed on these shelves.
INSTRUCTIONS AND INFORMATION REGARDING THE DISPOSAL OF USED PACKAGING
Take the used packaging material to the municipal waste disposal.
PRODUCT DISPOSAL AFTER END OF LIFE
Dispose of equipment after the end of life in the designated municipal solid waste place
This product meets all the basic requirements of EU directives that apply to it.
F
Top shelf head
G
Metal screw
H
Connecting rod
I
Allen key
J
Screw
8 – EN
K
Plastic anchor
L
Wall plate
M
Connecting screw
N
Washer under the screw
M
, see pictures 4A and 4B,
Publicidad
