GE AEL24 Manual Del Propietario Y Instrucciones De Instalación página 11

PREPARE THE CASE (continues)
4
Slide the left and right accordion panels into
E
the top and bottom mounting rails.
Top left
Bottom mounting rail
F Attach the side retainers to the case using 6 type
A screws.
PREPARE THE WINDOW AND INSTALL
5
THE CASE
A
Cut the window seal (2 long strips) to the proper
length. Peel off the backing and attach the seal to
the underside of the window sash.
Open the window and mark the center of the
B
window sill.
Carefully slide the case into the window and
C
center the case. Lower the window behind
the top mounting rail. Pull the bottom of the
case forward so that the bottom mounting rail
is tight against the back of the window stool.
Mount the case to the window sill using 2 type
C screws. Drill pilot holes, if necessary.
Stool
Installation Instructions
Top right
Sealing Strip
(with adhesive)
2 type C screws
PREPARE THE WINDOW AND INSTALL
5
THE CASE (continues)
D Assemble the V-support and V-support bracket
with Type F nut and bolt
Left
Sill angle
bracket
V-support Type
F bolt and nut
Position the V-supports
E
on the case bottom so
that they will be near the
outside wall. Attach a
V-support to each side of
the bottom of the case with
Type E bolts, 2 for each
support.
F
Adjust sill angle brackets to rest on sill.
Extend the left and right accordion panels
G
to the vertical window sashes. Drill pilot holes and
attach the top corners with 2 type C screws.
Type C
screw
11
Type E bolt
and nut
Right
V-support
Sill
Bracket
Type C
screw