ENGLISH
•
To attach a comb, first ensure the adjustable zoom wheel is set to 1. Then slide on the
desired comb so that the comb rails align into the slots found at the top of the trimmer
head.
•
Select the comb length by rotating the zoom wheel upwards to increase the length and
downwards to decrease the length. Please see the table below for the different length
increments.
Setting
1
2
3
4
5
6
7
8
9
•
To remove the comb, with the adjustable zoom wheel set to 1, pull the comb off the
beard trimmer.
•
For a more detailed, precision stubble look, attached the adjustable stubble comb
which can trim hair between 1 to 5mm. The cutting lengths increase in 0.5 increments.
•
Please note that the adjustable zoom wheel does not increase the length settings on
the stubble comb. To adjust these length settings, turn the dial found on the back of the
stubble comb which will then indicate the different trimming lengths to choose from.
•
Note: The below instructions are recommended for those with or wanting to trim beard
hair between 1.5 to 18mm in length.
BEARD BIB
The beard bib is designed to collect hair during trimming in order to prevent mess and
making disposal of hair clippings easier.
1. The suction hooks are designed to fix to a smooth non-porous surface such as a mirror
or ceramic bathroom tiles. Position them horizontally at about shoulder height. Rotate
the hook downwards to activate the suction hook (fig. D).
2. Fasten the bib around the neck then hook the loops over the suction hooks (fig. E)
3. When finished, leave the bib fastened around your neck then unhook the loops and
bring the two ends of the bib together. Keep the ends raised to contain the hair
clippings.
4. Lower the end of the bib over a waste bin and gently shake out the hair clippings using
the bib as a chute to guide the clippings into the bin.
6
Short Comb
1.5mm (Grade 0)
2.5mm (Grade 1)
4mm
5.5mm (Grade 2)
7mm
9mm (Grade 3)
11mm (Grade 4)
14mm (Grade 5)
18mm (Grade 6)
XL Comb
20mm
21mm
22mm (Grade 7)
23.5mm
25.5mm (Grade 8)
27.5mm
29.5mm
32mm
35mm