6. Adjust the length of two plastic bolts base on the length of through out from standard
electric cabinet to the wall. Confirm the two bolts fixing in the cabinet are in the same
length and vertical to the wall surface.
7. Fix the bottom cover to the electric cabinet by the accessory slotted head screws.
Confirm the bottom cover is parallel to wall surface.And then reinstall the bottom
cover to centralized controller. (See fig 3-7)
Over tighten the screw would cause rear cover deformed and LCD damage.
When installation, please maintain the screws and wire controller at the same height
level without deformed.
When installation, please reserve a certain length of wire controller connective cable
for future maintenance to take off the wire controller.
NOTE
42
Fig 3-7