Ryobi GD200 Manual Del Operador página 33

 Insert a flat head screwdriver into the tabs on the indoor
keypad and remove the back cover.
 Hold the back cover against the wall. Use a pencil and a
level to mark screw hole placement.
 Mount the back cover to the wall using screws. Install
screws using Phillips screwdriver.
NOTE: Use screws and drywall anchors when installing
the keypad into drywall.
 Fit the wires included with the indoor keypad into the
notch on the back cover.
 Connect the keypad to the back cover. Be careful not to
damage the wires.
 Route the wires from the keypad to the keypad wire
terminals. Attach the wires to the wall and ceiling using
the insulated staples.
 Insert the red striped wire from the keypad into the left
keypad terminal marked with R.
Pencil
Back
Screw
Cover
Screws
Wires
INSTALLATION
 Insert the white wire into the right terminal marked with W.
Entrapment warning label contains important safety
information. Install entrapment warning label next to the
indoor keypad in a prominent location. Use insulated
staples or other mechanical means if the label will not
adhere to the wall.
 For details about using the indoor keypad, see Using the
Indoor Keypad in the Operations section.
Fig. 57
Notch
Fig. 58
33 - English
WARNING:
Entrapment
Label
Wires
Wire Terminal
(Keypad)
Fig. 59
Fig. 60