28 OPERATION
Cold Wash
Use this option to save energy by using cooler
water while increasing the wash and rinse times to
maintain wash performance.
• Wash time will increase up to several minutes
with this option.
• Selecting this option increases the water
supplied during rinsing. The water supplied
during washing is not increased.
• For best wash results, only wash small loads (less
than 8 lb) with this option.
Signal
The washer plays a melody when the wash cycle is
finished. The buttons make a sound each time they
are pressed.
• Press and hold the Cold Wash button for 3
seconds to turn the sounds on or off.
• When no signal is heard, the signal is off.
Delay Wash
Once you have selected the cycle and other
settings, press this button to delay the start of the
wash cycle.
• Each press of the button increases the delay
time by 1 hour, for up to 19 hours.
• Once the desired delay time is set, press the
Start/Pause button to start the delay time.
NOTE
• If the Start/Pause button is not pressed to begin
the delay time, the washer automatically turns
off after a certain time and all cycle settings are
lost.
Rinse+Spin
Select this option to rinse and spin a load
separately from a regular cycle. This can be helpful
in preventing fresh stains from setting in fabrics.
1
Press the Power button to turn on the
washer.
• Do not select a cycle.
2
Press and hold the Delay Wash button for 3
seconds.
• You can change the spin speed by pressing
the Spin button.
3
Press the Start/Pause button to begin.
Water Plus
Use this option to add extra water to the wash
cycle for better wash performance with large or
bulky items.
NOTE
• If the washer reaches its maximum water level,
this button will have no effect.
• To add more water while a cycle is running,
pause the cycle and select this option.
• When you select Normal cycle and Water Plus
option, the cycle will be changed to Deep Wash
cycle before starting.
Soak
This option provides a 30-minute presoak prior to
the start of the selected cycle. Use this option to
presoak garments to help remove difficult spots or
stains on fabrics. At the end of the presoak time,
the selected cycle will begin with the same water
used for soaking.
• Press and hold the Water Plus button for 3
seconds to activate or deactivate this option.
Extra Rinse
This option adds an extra rinse to the selected
cycle. Use this option to help ensure the removal
of detergent or bleach residue from fabrics.
• Pressing the Extra Rinse button twice will add
two additional rinses to the cycle.
• If a liquid fabric softener is used, it is always
dispensed in the final rinse.
NOTE
• You cannot select this option with the Spin Only
option and Tub Clean cycle.
• Selecting the Extra Rinse option with the
Normal cycle automatically changes the cycle to
the Deep Wash cycle.
Control Lock
Use this function to disable the controls. This
function can prevent children from changing
cycles or operating this washer.