Descargar Imprimir esta página

Stell SHO 3600 Manual De Instrucciones página 13

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
Mounting the brackets on the TV set
TV set with fl at rear wall (Fig. 4A)
First, fi nd screws suitable for using to mount the TV set (D/E/F): try to screw them manually in the holes at
the back of the TV set. If you feel resistance stop screwing in immediately! Once you fi nd the screw with the
correct threat, proceed according to the drawing. Insert matching washer on the screw (I) and then screw
it into the bracket B and fi nally in the TV set. Check that the brackets are attached vertically and are parallel.
TV set with curved rear wall (Fig. 4B)
First, fi nd screws suitable for using on the TV set. (F/G/H): try to screw them manually in the holes in the
back of the TV set. If you feel resistance stop screwing in immediately! Once you fi nd the screw with the
correct threat, proceed according to the drawing. Attach matching washer on the screw (I) and spacer
(J/K) or their combination as needed and according to the diagram in the picture 4B. Then screw the screw
into the bracket B and fi nally in the TV set. Check that the brackets are attached vertically and are parallel.
Attaching the TV to the bracket and securing with safety screws
Warning: Handling some TV sets requires help of another person. The manufacturer is not liable for injury or
damage to property caused by improper handling!
First, hook the brackets attached to the TV set (2× B) on the top edge of the body of the holder A, then push
the bottom part of the brackets to the bottom part of the holder and tighten the safety bolts located at the
bottom part of both brackets using Phillips screwdriver (Fig. 6). Set the desired angle of the screen and using
the Allen key (C) tighten the screws on the body turning them by 180°, see fi g. 7.
Congratulation, the installation is done. We wish you a pleasant experience while watching TV mounted on
the wall mount.
INSTRUCTIONS AND INFORMATION REGARDING THE DISPOSAL OF USED PACKAGING
Take the used packaging material to the municipal waste disposal.
PRODUCT DISPOSAL AFTER END OF LIFE
Dispose of equipment after the end of life in the designated municipal solid waste place
This product meets all the basic requirements of EU directives that apply to it.
13 – EN

Publicidad

loading