English
Contents
English
Introduction ................................................19
Preparations ..............................................21
Use ............................................................22
Maintenance ..............................................22
Faults .........................................................25
Spare parts ................................................29
Preface
This manual contains instructions for use of
the heaters as shown on the cover. The
information in this manual is important for the
correct and safe use of the heater.
Identification of the product (fig. 1)
The identification plate is attached to the side
of the heater. The identification plate contains
the following data:
A
Year of manufacture
B
Serial number
C
Production code
D
Voltage data
E
Capacity max (kW)
F
Capacity max (MJ/h)
G Type number
Service and technical support
Please contact your dealer or the
manufacturer for information about the
heater. Make sure you have the following
data at hand: type and serial number of the
heater.
Warranty and liability
For warranty and liability, see general
warranty regulations.
18
Environment
1
1.1
40.020.933 - rev. 04 - 2011
Note
The heater is made of various metals
and synthetic materials. The heater
also contains electronic parts, which
must be treated as electronic waste.
Please contact your dealer for further
information.
Only applicable to the European
Union
Waste disposal of electric &
electronic equipment for business
use.
For further information regarding the
disposal of products for business use
at the end of their life span, please
contact your dealer or distributor in
your country. This product may not
be disposed of together with
commercial waste or as commercial
waste.
SAFETY INSTRUCTIONS
Pictograms in this manual
Caution
Indicates risk of damage to the
appliance.
Warning
Indicates a dangerous situation, that
can lead to death or serious injuries.
Warning
Always switch off power when
performing maintenance or repairs on
the hot air heater!
Hot
Some surfaces may be hot! Wait until
these parts have sufficiently cooled
down before performing
maintenance.
AT 300 series