Publicidad
Idiomas disponibles
Idiomas disponibles
USING THE SPOT CLEANER
See Figures 5 - 7, pages 8 - 9.
WARNING:
Always hold the unit at an angle with the nozzle of the
tool facing down when vacuuming liquids or when the
waste tank contains liquid waste. Positioning the unit on
its side or holding the unit with its nozzle facing up could
allow liquid to enter into the motor or battery. Battery
packs exposed to liquids can result in smoke/fire, serious
personal injury and/or property damage.
CAUTION:
Apply the cleaning solution sparingly to complete the
task. Excessive foaming may occur if too much cleaning
solution is present.
When using, monitor the amount of liquid waste present in
the waste tank. Do not allow the amount of waste liquid to
exceed the max fill line. When the waste tank reaches full
capacity, turn the unit OFF and empty the waste tank.
When you are finished, remove and clean the filter as
described later in this manual. Allow the filter to dry before
reassembling the unit.
WARNING:
During use, make sure the unit does not get submerged
or doused in liquid, which could cause shock, unit failure,
or personal injury.
REMOVING/EMPTYING/REATTACHING THE
WASTE TANK
See Figures 8 - 9, page 9.
The waste tank should be emptied every time the solution tank
is filled to avoid exceeding the tank's max fill line. Remove
and clean the waste tank after every use.
NOTE: The waste tank is top rack dishwasher safe up to 140°F.
WARNING:
Never allow the amount of waste liquid to exceed the
max fill line. Failure to follow this rule may allow liquid to
enter inside the unit which could cause shock, property
damage, or personal injury.
OPERATION
To remove:
Remove the battery pack.
Place the unit on a level surface.
CAUTION:
If the waste tank contains liquid, do not turn the unit
upside down as it may enter the motor.
Using your right thumb, press the waste tank release
button. The waste tank will release.
Continue pressing the release button and lift the unit. The
waste tank should remain on the level surface.
To empty:
Move the waste tank over a suitable container or drain.
Raise the waste tank latch to unlock the tank.
Empty the contents and rinse the tank.
Close the lid and be sure it is securely latched.
To reattach:
Reinstall the tank by inserting it into the unit and press-
ing it into place until the waste tank release button locks
securely.
NOTE: The hinge of the tank will face toward the front of
the unit. The tank should easily lock into place. Do not
force it. If the unit will not lock into place, try turning the
tank around and trying again.
CLEANING THE INTAKE NOZZLE
See Figures 10 - 11, page 9.
The intake nozzle should be cleaned after every use.
NOTE: The intake nozzle is top rack dishwasher safe up
to 140°F.
To remove:
Remove the battery pack.
Place the unit on a level surface.
Grasp the handle with your right hand. Place your left
hand over the front of the unit.
Using your thumb and middle finger, pull on both tabs
and away from the unit. The nozzle will slide out and away
from the unit.
Clean and rinse the intake nozzle with fresh water.
NOTE: Allow the nozzle to air dry completely before
reinstalling when preparing the unit for storage.
To replace, align the nozzle and insert it into the unit.
Once installed in place, press on both the top and the
bottom of the nozzle to make sure both tabs are secure.
6 — English
Publicidad
