EINHELL CC-JS 18 Manual De Instrucciones Original página 17

LED status signals on the jump start cable
•
Fig. 4a: Green LED = Start engine
•
Fig. 4b: Green LED flashing + acoustic war-
ning signal = Press the „Boost" button and
start the engine within 30 seconds.
•
Fig. 4c: Red LED + acoustic warning signal =
Battery connected reverse polarity (see 2.)
•
Fig. 4d: No LED, no acoustic warning signal =
Check the connector to the equipment, press
the „Boost" button and start the engine within
30 seconds.
The number of times that you can attempt to start
the engine (max. 10) varies according to the am-
bient temperature, the condition of the battery you
want to start and the charge level of the jump start
power bank battery.
9. Cleaning, maintenance and
ordering of spare parts
Hazard!
Always pull out the power plug before starting any
cleaning work.
9.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
•
We recommend cleaning the equipment im-
mediately each time after use.
•
Clean the equipment regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may be ag-
gressive to the plastic parts in the equipment.
Ensure that no water can get into the interior
of the equipment. The ingress of water into
an electric power tool increases the risk of an
electric shock.
9.2 Maintenance
There are no other parts inside the equipment
which require maintenance.
Anl_CC_JS_18_SPK7.indb 17 Anl_CC_JS_18_SPK7.indb 17
GB
9.3 Ordering spare parts
Please provide the following information when
ordering spare parts:
•
Type of unit
•
Article number of the unit
•
ID number of the unit
•
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
10. Repair
Should the tool experience problems beyond
those mentioned above, let only an authorised
professional or a customer service shop perform
an inspection.
11. Disposal and recycling
The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
12. Storage
Store the equipment and its accessories in a dark
and dry place at above freezing temperature. The
ideal storage temperature is between 5 and 30°C.
Observe the enclosed safety information with
detailed information about storage. Since the bat-
tery reacts if the temperature is too high (above
+40°C) or too low (below 0°C), do not keep the
battery permanently in a vehicle. For transporting
in a vehicle, place the equipment in a suitable
location where it cannot move in response to an
abrupt change in speed and/or direction. Keep
the equipment in its original packaging.
- 17 -
08.01.16 11:32 08.01.16 11:32