Hilti NURON SMT 6-22 Manual De Instrucciones página 30

CAUTION
Risk of injury by clamping lever snapping back.
▶ When closing the clamping lever, do not allow the clamping lever to snap back in an uncontrolled manner.
Hold the clamping lever firmly and close it with caution.
The STARLOCK MAX tool mount is compatible with STARLOCK PLUS and STARLOCK accessory
tools.
1. Set the accessory tool on a flat surface.
2. Open the clamping lever completely by turning it counter-clockwise past the first detent to the stop.
▶ The clamping jaws of the tool holder are closed.
3. Align the star-shaped tool mount of the product with its counterpart on the accessory tool and set the
product on the accessory tool.
4. Close the clamping lever completely by turning it clockwise in a controlled manner past the first detent
to the stop.
▶ The clamping jaws of the tool holder open, holding the accessory tool securely engaged.
5. Check that the accessory tool is held securely.
5.6 Removing accessory tool
CAUTION
Risk of injury due to accessory tool! The accessory tool might be hot or have sharp edges.
▶ Wear protective gloves when changing the accessory tool.
CAUTION
Risk of injury and damage due to falling accessory tool. The accessory tool can fall off and lead to injuries
and/or damage to accessory tool and underlying material.
▶ Hold the product and the accessory tool above but close to a surface when you remove the accessory
tool.
1. Open the clamping lever by turning it two clicks counter-clockwise.
▶ The accessory tool is released and separates from the tool holder.
2. Close the clamping lever by turning it clockwise.
5.7 Fall arrest
WARNING
Risk of injury by falling tool and/or accessory!
▶ Use only the Hilti tool tether recommended for your product.
▶ Prior to each use, always check the attachment point of the tool tether for possible damage.
▶ Do not secure a tool tether to the belt hook. Do not use a belt hook to lift the product.
Comply with the national regulations for working at heights.
As drop arrester for this product, use only a combination of the Hilti retaining strap and the Hilti tool tether
#2261970.
▶ Secure the retaining strap to the installation openings for accessories. Check that it holds securely.
▶ Secure one carabiner of the tool tether to the retaining strap and secure the second carabiner to a
load-bearing structure. Check that both carabiners hold securely.
Comply with the operating instructions of the Hilti retaining strap and those of the Hilti tool tether.
24 English 2381015
*2381015*