Publicidad
Idiomas disponibles
Idiomas disponibles
• The speakers may be overloaded or defective, lower the level and remake
the level adjustment. This setting can be adjusted as follows:
a) On the radio/player, place any musical signal and set the volume to
80% of the maximum (if the maximum volume of the radio /player is 45
(100%), set to 36 (80%).
b) On the amplifier, with GAIN control at minimum, increase gradually
until the LED CLIP starts to flash. Slowly return the GAIN until the led goes
out completely.
LACK OF BASS:
• Cables of the speakers may be reversed
NOISE AND FAILURE IN SOUND:
• Verify that the installation is not close to the original vehicle wiring as
they may cause interference and noise in the audio signal.
• Make a separate power connection to the sound system.
Use a fuse/ circuit breaker as close to the battery as possible for protection.
• Make a good grounding of the amplifier. To do this, remove the paint
from the vehicle chassis at the desired point. Screw the wire using a ground
terminal. To protect from oxidation, isolate with paint.
• Do not loop the ground. Avoid using multiple grounds. If possible, use a
star connection, in which all the grounds run from a single point.
Any updates made in this manual will be available for costormers to consult without
any charge on the brand's site.
It is recommended that the updated manual be consulted whenever needed.
and
17
(out-of-phase speakers).
Publicidad
