Worx Nitro WG572E.X Manual De Instrucciones página 15

5. OPERATION INSTRUCTIONS
ASSEMBLY AND OPERATION
ACTION
ASSEMBLY
Assembling the blower tube
NOTE: Gently pull the blower tube to
ensure it is locked into place.
Air speed mode
NOTE: The blower has two working
modes: air speed mode and air volume
mode. To change modes, depress
the nozzle release button and slide
backward for air speed mode. Slide
forward for air volume mode.
Choose a suitable mode according
to your work. Air speed mode is
recommended for cleaning in grass,
as shown in Fig. K1. While air volume
mode is recommended for cleaning
on hard ground such as cement, as
shown in Fig. K2.
Air volume mode
Connecting the backpack to the
blower
NOTE: Check and make sure the
blower is locked into position.
Checking the battery capacity
NOTE: Fig. D only applies for the
battery pack with battery indicator
light.
Charging the battery pack
Your battery pack is UNCHARGED, you
must charge before use.
More details can be found in charger's
manual.
NOTE: This machine will only run
when separate-batteries are installed.
It is recommended to use the same Ah
batteries and charge the 4 batteries at
the same time.
WARNING! The charger and
battery pack are specially
designed to work together, so do not
attempt to use any other devices.
Never insert or allow metallic objects
into your charger or battery pack
connections because of an electrical
failure and hazard will occur.
Cordless Backpack Blower
Battery indicator light
See details in BATTERY STATUS
part.
Press the battery indicator button,
FIGURE
the light will be on to indicate the
lower common denominator, after
3s, status of each battery pack will
be shown on.
See Fig. A1,A2
Connecting the basecamp to the
backpack
NOTE: When fitting, gently pull the
basecamp to ensure that it is securely
installed.
Positioning the backpack blower
Put your arms through the backpack
straps to support the blower on your
See Fig. A2
back.
Adjust both shoulder straps to
comfortable positions.
Snap the chest buckle and adjust its
length if necessary.
Adjusting the control handle
See Fig. B1,B2
OPERATION
Starting
See Fig. C1,C2
NOTE: To stop the blower, release the
trigger. When you use 4 batteries with
different Ah, the machine will only run
to the lower common denominator.
See Fig. D
switched off. Let the motor come to a
complete standstill before setting the
tool down.
Adjusting the blowing speed / air
volume
To increase the air speed, pull the
variable-speed lever downward when
the blower runs; to reduce the air
speed, push the knob upward.
See Fig. E
Storage
USER TIPS
- Hold the blower tube approximately 2m above the
ground when operating the tool.
Use a sweeping motion from side to side. Advance
slowly keeping the accumulated debris/leaves in
front of you.
- After blowing the debris/leaves into a pile, it is easy to
dispose of the pile.
WARNING! The tool runs for a
few seconds after it has been
See Fig. F
See Fig. G1,
G2
See Fig. H
See Fig. I1,
I2, I3
15
See Fig. J
See Fig. K1,K2
See Fig. L
EN