Publicidad
Idiomas disponibles
Idiomas disponibles
OBJ_BUCH-2030-003.book Page 25 Thursday, January 23, 2014 10:38 AM
Do not leave the switched on measuring tool unattended and
switch the measuring tool off after use. Other persons could be
blinded by the laser beam.
To save energy, only switch the measuring tool on when you are using it.
Operation Modes (see figures A
Once the measuring tool has been switched on, it is in the automatic lev-
elling operation mode
eration mode .
To change the mode, repeatedly press the "Mode" button 2 until the de-
sired mode appears on the display.
The following operation modes are available:
Automatic levelling operation mode:
Indication
Mode
Cross-line mode (see figure A): The measuring tool gen-
erates a horizontal and a vertical laser line, the levelling of
which is monitored.
Horizontal mode (see figure B): The measuring tool gen-
erates a horizontal laser line, the levelling of which is mon-
itored.
Vertical mode (see figure C): The measuring tool gener-
ates a vertical laser line, the levelling of which is moni-
tored.
The self-levelling range of ±4 ° is exceeded, self-levelling
is not possible (display flashes). The laser line goes out.
Tilt function with angle indicator operation mode:
Indication
Mode
Horizontal mode.
Horizontal mode. The measuring tool is tilted to the left.*
* Tilt angle h and laser lines are only indicated from an incline of > ±2 °.
Bosch Power Tools
D)
–
or in the tilt function with angle indicator op-
1 618 C00 93G | (23.1.14)
English | 25
Publicidad
