OPERATION
Room temperature sensor selection
THERMO
SENSOR
Press the THERMO SENSOR button to select whether the
room temperature is detected at the indoor unit (remote
sensor) or the remote controller.
When the
thermo sensor display appears, the room
temperature is detected at the remote controller.
NOTES
•
This function is locked at the factory. In order to detect the room temperature correctly, consult authorized service
personnel when using this function.
•
If this function is locked, the location where the room temperature is detected cannot be changed and the
flashes when the THERMO SENSOR button is pushed.
Part lock function
DAY
CLOCK ADJUST
DAY OFF
SET BACK
DELETE
SET
ON/OFF TIMER
Instructions related to heating are applicable to "HEAT PUMP MODELS" and "HEAT RECOVERY MODELS" only.
The timer function is not available depending on the model.
To set the ON/OFF timer
Press the TIMER MODE button to
1
select the ON TIMER or OFF
TIMER.
CLOCK ADJUST
No display
NON
OFF
STOP
TIMER
G To cancel the timer mode
DELETE
• Press the DELETE button to cancel the timer mode.
• The timer mode can also be canceled by changing the timer mode using the TIMER MODE button.
En-5
Press the DAY (DAY OFF) button and SET button simulta-
neously for 2 seconds or more to activate the part lock
function and lock all of the buttons on the remote con-
troller except the Start/Stop button, Set Temperature but-
tons, Master Control button, and Fan Control button. Press
the buttons again for 2 seconds or more to deactivate the
part lock function.
When the part lock function is activated, the
appears. If any button is pressed during the part lock, the
PL
display flashes.
ON
WEEKLY
TIMER
TIMER
Indoor unit
mark
2
From 1 to 24 hours
ex. OFF timer set for 6 hours
Press the SET TIME buttons to set the time.
After the time is set, the timer will start automatically.
The amount of time until the OFF timer operates that is dis-
played on the timer display decreases as time passes.
mark
SU MO TU WE TH FR SA