Garland BOLT 525 Q Manual De Instrucciones página 38

English
Always readjust the machine in a flat stable surface.
Do not expose the machine to rain or humid
conditions. Water that enters the machine
increases the risk of electric shock.
Don't only use the security features of this machine.
It is necessary to pay attention to the possible
loosening or overheating of the parts of the machine.
If you detect any abnormality immediately stop the
machine and check it carefully. In case of failure take
the machine to the technical service for repair. Under
no circumstance should you continue working if you
notice that the machine is not working correctly.
Remember to always use the machine with clean
hands and without remains of fuel or oil.
Be careful not to touch the hot parts of
the machine while the engine is running
or after use, as for example the exhaust,
spark plug or high voltage cables. Do not
connect two or more generators in a series or parallel.
Do not connect the 12V wires to opposite poles.
Remember that the red clamp attaches to the positive
pole (+) and the black clamp on the negative pole (-)
do not use accessories on this machine except those
recommended by our company since its use could
cause severe damage to the user, people close to the
machine and the machine.
Always follow all the security rules indicated in this
manual.
7.1. USING THE MACHINE
- Start the machine following the instruction in the
manual.
- For 3 minutes keep circuit breakers in the OFF
position to warm up the engine without load.
- If you are using alternating current (AC) select
the circuit breaker in alternating current (AC). (The
generator cannot supply both alternating current
(AC and DC current (DC)).
- Connect the appliance to the generator.
- If the connected device has higher consumption
that the generator can produce, the circuit breaker
will cut off electricity supply to protect the
generator.
- If this occurs unplug the electricity for at least one
minute, reconnect the circuit breaker.
7.2. VERIFICATION POINTS AFTER COMMISSIONING
Check that the noise of the machine is normal and
that it does not vibrate. If you detect any anomaly
in the machine stop immediately. In case of any
malfunction or problem take the machine in for
service to be repaired. In no circumstance should you
continue to use the machine if the operation does not
seem appropriate.
Check the voltmeter brand 220-230V. If the voltmeter
mark voltage is too high or too low to stop the
machine immediately.
Do not use the machine if it is damaged or improperly
adjusted.
7.3. TIPS FOR USE
- If you are connecting two or more devices to the
generator, connect them one by one starting with
the one using the most power.
- Remember that most of the devices require
more power than specified in the label to boot. It
could happen that this generator, although capable
of supporting the consumption of the appliance in
operation, cannot generate the energy needed for
its start-up.
- If you use this generator to give power to a
circuit of a house have the operation performed
38/120