Idealgas Vulcan 3000 Manual De Instrucciones página 7

• Make sure to close the faucet and that the flame extinguishes before proceeding to the removal of the gas container.
• Before the insertion of a new cartridge always verify that the gaskets (between the instrument and the gas cartridge or container)
is in perfect conditions and correctly situated.
• Control that the injector is not obstructed, otherwise remove the eventual deposits with a pin.
• The substitution of the gas container has to happen to the open one, away from flames and sparks or rising of heat and away from
other people.
• Control the gaskets before applying a new cartridge
• The empty gas containers must adequately be eliminated.
LIGHTING:
• Make sure that the gas handle grip is closed.
• In case of leakages (gas smell) extinguish the instrument and immediately bring it outdoor, far away from heat sources. Check the
leakages using the special spray or soap water (the presence of beads determines a loss). Do not use free flames.
• Open of the handle grip of gas regulation.
• If the product is endowed with electric ignition, push repeatedly on the piezo button, otherwise approach a flame to the superior
part of the gas diffuser.
• Adjust the flame through the faucet according to the demands.
• CAUTION: do not shake or tilt the tool during the lighting.
• In phase of lighting they could happen some most consistent blazes; this phenomenon is contemplated and it lasts few seconds.
• After the use attend the complete tool cooling. The tool must be stocked in vertical position, in fresh a dry and ventilated place,
far away from children. Never put back in cellars or basements.
• CAUTION: If the instrument is endowed with electric ignition and the product itself doesn't ignite, this could be caused by damp.
Dry the ferrule before proceeding to a new lighting having care not to move it from the position in which it is (5-8 mm from the
contact spark point). Don't press the piezo button during the ferrule drying.
ONLY FOR THE LAMPS:
• After the first lighting never touch the mantle it can break. It is essential to light the first time outdoor because of the smoke
emissions.
• If the lamp is endowed with electric ignition the ferrule has to cross the mantle.
MAINTENANCE
FOR THE LAMPS: mantle replacement
• Remove the handle throwing the two extremities, widen the crossbars and remove cover and glass.
• Keep away the ruined mantle.
• Insert the new mantle (see figure)
• Reassemble in the order glass, cover and handle.
See the explaining drawings at page 28
FOR ALL THE INSTRUMENTS:
• Don't modify or mend the instrument.
• For possible malfunctions contact a service centre.
• The producer is not responsible for damages caused to things or people owed reparations performed by not authorized people,
the use of non appropriate gas containers, tool changes or tampering.
• For reparations or substitutions, remove the gas container and adequately pack the tool before sending it for the maintenance.
5